Stepper Draws A4 Cardstock size.

This was a Stepper Card Design that I saw  Here

This one is made with an A4 piece of cardstock.

 

If you want it inches.

Draw a line on back of your cardstock.

Make a mark 4 1/8" down and 1 1/4" in from the edge.

Turn the card round and make a mark in the same place on the other side of the cardstock.

Use a ruler and cut this line with a knife.

Every line you score goes upto but not over this line.

With the right side of your card facing you score at 6", until you meet the cut line.

This is the step on the left in the photo.

Now score at 1 1/4"  from the cut line to the edge.

At 2 1/2" and at 7 1/4"

The Pink layer with the flower measures 3 3/4" by  4 1/4"

The draws measure  3 3/4" by 1 1/4".

Draw a line on back of your cardstock.

Make a mark 10.5 cm down and 3cm in from the edge.

Turn the card round and make a mark in the same place on the other side of the cardstock.

Use a ruler and cut this line with a knife.

Every line you score goes upto but not over this line.

With the right side of your card facing you score at 15cm, until you meet the cut line.

This is the step on the left in the photo.

Now score at 3cm from the cut line to the edge.

At 6cm and at 18cm.

This gives you the base.

The Pink layer with the flower measures 9.5cm by 11cm.

The draws measure 3cm by 9.5cm .

I inked the edges to make them stand out.

I added an eyelet as a handle and used my punches to decorate the base of the design.